Ping; Reboot; Reset; Save - Redline RDL-3000 Series User Manual

RDL-3000 FAMILY
conn <id>
Create a new Service. Equivalent to 'new service <id>' This command is provided to
support migration from AN-80i systems.
id - Specify a unique ID for this new service.
group <id>
Create a new Service Group.
id - Specify a unique ID for this new Service Group.
link <id>
Create a new Link.
id - Specify a unique ID for this new Link.
service <id>
Create a new Service.
id - Specify a unique ID for this new Service.
tplink <id>
Create a new link template for use with the STID feature. Use the same commands
applicable to configuring a standard link.
id - Specify a unique ID for this new link template.

ping

Use the ping command to initiate an ICMP ping command from the RDL-3000. This can
be used to confirm network access to FTP/TFTP servers, syslog servers, etc.
ping <IP address> <Number of Packets> <Length>
IP address
Number of Packets Number of ICMP packets to send (1 to 16).
Length

reboot

Use the reboot command to reboot the RDL-3000 firmware.
reboot <delay>
delay Number of seconds to wait before rebooting (60 max.).Enter 'reboot 0'
Note: Use this command in combination with Apply to temporarily test changes to the
configuration. For example:
reboot 60
apply
{ test changes}
reboot 0

reset

Use the reset command to zero the RDL-3000 statistics or ID table.
reset <stats>
Clear statistics counters.
stats <id>
Reset statistics for a Service Group, Service, or Link.
id - Specify an ID to reset statistics only for that Service Group, Service, or

save

Use the save command to copy edited parameter settings into non-volatile memory.
save [option] <Enter>
70-00158-03-00
USER MANUAL
IP address of target.
Not supported in this software release.
(zero) to cancel a pending reboot.
Schedule reboot in 1 minutes
Activate configuration changes (without saving)
Cancel reboot
Link. Default is to reset all statistics.
Proprietary Redline Communications © 2015 Page 126 of 254 April 17, 2015