Snmp Trap Configuration; Fig. 39: Web - Snmp V3: Trap Configuration Screen - Redline RDL-3000 Series User Manual

RDL-3000 FAMILY
SNMP v3: Edit Trap Configuration
The following screen is displayed when SNMP v3 is selected. Click
the SNMP Trap Destinations section of the screen to modify the list of trap listeners. The
following popup dialog is displayed:
Index: Display the unique reference number for this entry. This value is required when
using the CLI interface to modify SNMP trap settings.
IP Address: Enter the IP address (IPv4) associated with this SNMP trap alarm.
Port: Enter the destination port address associated with this SNMP trap alarm.
User Name: Enter the user account associated with this trap destination.
Change Trap: Click to accept changes and close this dialog.
Delete Trap: Click to remove this trap.

SNMP Trap Configuration

This portion of the screen is common for SNMP v2 and v3.
SNMP Traps Enabled: Control the SNMP trap message function.
Disabled ( ): The RDL-3000 does not send SNMP trap messages.
Enabled ( ): The RDL-3000 sends SNMP trap messages.
Link Up/Down Trap Enabled: Control SNMP trap messages for the link status.
Disabled ( ): The RDL-3000 does not send SNMP trap messages based on
changes to the wireless link status.
Enabled ( ): A trap message is sent for each change to the wireless link status.
Apply: Click to activate the displayed SNMP Trap Destinations and SNMP Trap
Configuration settings.
Apply & Save All: Click to activate and permanently save the SNMP Trap Destinations
and SNMP Trap Configuration settings displayed on this screen.
Note: Unsaved changes on the current screen are discarded when changing to another
screen before clicking Apply or Apply & Save All.
70-00158-03-00
USER MANUAL

Fig. 39: Web - SNMP v3: Trap Configuration Screen

Proprietary Redline Communications © 2015
Change
Page 71 of 254
or Add in
April 17, 2015