Genecckeys; Generate; Get - Redline RDL-3000 Series User Manual

RDL-3000 FAMILY
Local frequency ranges:
index begin end
0 5810.0 5820.0
1 5830.0 5835.0
reload
Reload the active list of frequency validation ranges.

genecckeys

Use the genecckeys command to self-generate public/private keys and generate a
'certificate request' file. The key file is saved permanently in the user (usr) table
(ecc_keypairT.ecc) and the 'certificate request' file is automatically downloaded to the ftp
server.
genecckeys <tftpserver_IP><cert-req-name>
ftpserver_IP
cert-req-name

generate

Use the generate command to generate a DSA key for use with SSH. The generated
key is saved in runtime memory and non volatile RAM. A system reboot is required to
activate the new key.
generate <sshkey>
The RDL-3000 generates a key using its internal encryption module.
sshkey <dsa | rsa>
dsa
rsa

get

Use the get command to view system parameters. Use the following general format to
view a parameter.
get <parameter>
activeids
Number of active IDs (Services, Service Groups, and Links).
activelinks
Number of active Links.
antalign
Display the current RSSI values for RF 1 & RF 2 to assist antenna alignment.
cirsubratio
Current CIR Subscription Ratio %.
dldpkt
Number of downlink discarded packets.
dloir <id>
Get the downlink offered information rate for the service.
dlrpkt
Number of downlink Rx packets.
dltpkt
Downlink Tx packets.
70-00158-03-00
USER MANUAL
IP address fo the destination TFTP server.
Filename for the certificate request file.
Generate DSA key for SSH.
Generate RSA key for SSH.
Proprietary Redline Communications © 2015 Page 120 of 254 April 17, 2015