Fig. 41: Web - Subscriber: Ras Advanced Stat. - Auto Scan Status - Redline RDL-3000 Series User Manual

RDL-3000 FAMILY
Important: This screen is provided for advanced users to diagnose system operation in
challenging environments.
This screen is not available from the Web interface. The diagnostic URL must be entered
manually by the operator.
Example:
http://192.168.25.2/adm/ascansts.html

Fig. 41: Web - Subscriber: RAS Advanced Stat. - Auto Scan Status

Auto Scan Status Fields
Frequency: Channel frequency in-use by the detected sector controller.
Beam #: The beam (direction) of the sector conroller signal.
RSSI [dBn]: Received signal strength indicator measured on the signal from this
sector controller.
SNR [dB]: Signal to noise ratio measured on the signal from this sector controller.
SC ID: Unique sector controller identification number (see SC General Information
screen).
Registration Attempts: The number of times the subscriber has attempted to
register with the listed asector controller.
RF Frequency [MHz]: Enter the center frequency for the RF channel.
Important: You MUST reboot the RDL-3000 after changing this parameter.
Available channel frequencies are based on the region code and radio type. Refer to
section 8.1: Regional Codes on page 172. The radio type information is displayed in the
General Information
Frequency Scan is enabled.
IMPORTANT
proximity, RF frequency settings should be separated by a guard interval equal or
greater than the channel size. For example, when using a 10 MHz channel, the RF
frequencies should be separated by >10 MHz.
Channel: (UHF band only) Select the RF channel. This field is displayed only when
enabled by an options key (
channels (US and Canada only). See WSDB Control for requirements when operating in
the US.
Tx Power: Enter the transmit power level in dBm measured at each RDL-3000 RF port.
Tx power settings are controlled by options keys. Factory default and operation with no
options key is -5 dBm. All units require upgraded options keys to activate higher TX
power settings. Maximum power is limited by regional regulations and the (integrated)
antenna type. When DFS is enabled, the subscriber Tx power may be adjusted
automatically to avoid false triggering.
Note: To minimize potential RF interference, operator changes to the Tx Power setting
are applied in steps over a time interval (dB/s).
Important -- EIRP Levels: Where required by local regulations, the maximum
operational power per channel for a specific antenna must not exceed the maximum
allowable EIRP levels, The RF output power settings must be professionally
70-00158-03-00
screen. On subscribers, this setting is disabled when Auto
: To minimize interference between RDL-3000 links operating in close
) for systems operating in areas using TV Whitespaces
Proprietary Redline Communications © 2015
USER MANUAL
Page 74 of 254 April 17, 2015