RDL-3000 FAMILY
On - Disable link up/down trap.
off
Disable all SNMP traps.
on
Enable all SNMP traps.
print
List all SNMP trap settings.
spectrum
Use the spectrum command to start a sweep, check the sweep status, and display the
results. Operator must use the Web interface to configure the sweep parameters.
spectrum <print | run | status>
print
run
status
upgrade
Use the upgrade command to upload a new firmware binary file to the RDL-3000. The
file must be located in the default directory for the specified user account.
upgrade <ip addr> <file name> <user name> <password>
ip addr
IP address of the FTP/TFTP server.
file name
Name of the binary file to be uploaded.
user name
FTP account name (FTP server only).
password
FTP account password (FTP server only).
Notes:
1. TFTP: Specify the TFTP server address and the full name of the binary file (including
.bin extension).
FTP: Specify the FTP server address, account user name, account password, and
2.
the full name of the binary file (including .bin extension).
user
Use the user command to manage user accounts, passwords, and user Groups. When
in user mode, only the <chgpasswd> field is available, since the user can change only
their own password. The other commands are available only for members of the
administrator Group. The RDL-3000 supports administrator and user accounts.
user <add> <attr> <chgpasswd> <del> <print>
add <username> <usertype>
Administrators can use this command to add new user accounts. Usernames
may be 1 to 19 alpha-numeric characters including a-z, A-Z, 0-9, dash (-), and
underscore (_), Passwords may be 8 to 15 alpha-numeric characters including a-
z, A-Z, 0-9, dash (-), and underscore (_). The operator must confirm their own
password and a password for the new account.
70-00158-03-00
USER MANUAL
Print results of the last spectrum sweep.
Start a RF spectrum sweep.
Display the status and settings of the spectrum sweep feature.
Proprietary Redline Communications © 2015
Page
143
of 254
April 17, 2015