Cli Interface; Quick Reference; Table 18: Cli - Command Summary - Redline RDL-3000 Series User Manual

RDL-3000 FAMILY
4

CLI Interface

This section describes the procedures for configuring and operating the RDL-3000 using
CLI over a Telnet connection.
Note: Do not logout or issue new commands until the previous CLI command has
finished processing. For 'save config' or 'script' commands this may be approximately
three seconds. When writing script files, insert pauses after these commands.
4.1

Quick Reference

Online help is available for all commands. Use the Tab key for auto-complete functions.
The following table lists all RDL-3000 commands available from root mode (default
mode at login).
Command
apply
arp
chgver
clear
del
disable
enable
freq
generate
get
load
logout
new
ping
reboot
reset
save
script
set
show
snmpcommunity
snmptrap
spectrum
upgrade
user
whoami
70-00158-03-00
USER MANUAL

Table 18: CLI - Command Summary

Description
Activate changes without overwriting saved configuration.
Add a static ARP definition to the RDL-3000 ARP table.
Change default version of firmware and reboot.
Clear commands.
Delete an ID.
Disable an ID.
Enable an ID.
Enter frequency ranges for autoscan and DFS.
Create DSA key for SSH locally on RDL-3000.
Display the value of a statistic or parameter.
Load commands.
End the current Telnet session.
Create a new ID.
Send a ping message from the RDL-3000 system.
Reboot the RDL-3000.
Reset the RDL-3000 statistics values.
Save the selected configuration settings.
Generate a configuration script.
View/modify a system parameter value.
View system compound objects (e.g., configuration).
View/modify the SNMP community settings.
View/modify the SNMP trap settings.
Spectrum sweep commands.
Upload a firmware binary image to the RDL-3000.
View/modify the user/password configuration.
Display login name for this Telnet session.
Proprietary Redline Communications © 2015
Chapter 4
Page 116 of 254 April 17, 2015