Basic Wireless Configuration - Redline RDL-3000 Series User Manual

RDL-3000 FAMILY
Important: The operator MUST reboot the RDL-3000 after making changes to any of the
following RF parameters:
System Mode
Channel Size
RF Frequency
After making changes to the wireless settings, click Apply & Save All to permanently
save changes and then click Utilities ->Reboot.

Basic Wireless Configuration

System Mode: One unit must be configured as a sector controller to control the bi-
directional data link with remote subscribers.
Important: You MUST reboot the RDL-3000 after changing this parameter.
PMP SC: This unit is configured as a sector controller (sector controller). The unit
automatically begins transmitting poll messages to locate and register remote
subscribers. Enabled by Options Key.
PMP SS: This unit is configured to operate as a subscriber. The unit monitors the
selected RF channel(s) for poll poll messages from a sector controller.
Channel Size [MHz]: Select the channel bandwidth. Available channel sizes are based
on the options key, radio type and frame mode. The radio type information is displayed
in the General Information
Important: You MUST reboot the RDL-3000 after changing this parameter.
Auto Frequency Scan: (SS only) Check this box
The Auto Frequency Scan (AFS) feature reduces registration time by limiting the
subscriber channel search to a list of channels specified by the operator. Click on the
main menu item Configuration ->
Screen. When Auto Frequency Scan is disabled, the wireless link can be established
only at the frequency specified in the RF Freq. [MHz] field. A scan is started following
power-up/reboot, loss of the wireless link, and by the Scan Threshold feature.
When Auto Scan is enabled, a 'stickiness' timer can be set. This is the period a
subscriber will attempt to reconnect with the same sector controller following loss of the
wireless link. Refer to the Stickiness Timer settings on the following screens:
Subscriber:
Sector Controller:
Rescan: (SS only) Click this button to deregister the subscriber and start a scan.
The Rescan function is available only when Auto Frequency Scanning is enabled and
the subscriber is registered with a sector controller. When the subscriber is registered,
clicking Rescan immediately terminates the active wireless link to a sector controller and
frequency scanning is performed as described in the Auto Frequency Scan field above.
Also see the Scan threshold Enable feature on the
Note: When the subscriber is not registered and Auto Scan is enabled, the scanning
process cycles continuously without operator intervention. The scanning process can not
be interrupted and clicking Rescan has no effect.
Advanced Auto Scan Results
When operating the
frequency scan. This includes each the channel, RSSI, and SNR for each discovered sector
controller.
70-00158-03-00
USER MANUAL
Scheduling Cycle
Frame Mode
Frame Size
screen.
Frequencies
Wireless Configuration screen
Subscriber Link Configuration screen.
RAS-Elite
subscriber, the operator can access the results of the last
Proprietary Redline Communications © 2015
Downlink Ratio
Cyclic Prefix
Region Code (options key)
to enable the Auto Scan feature.
to display the Frequency Management
Subscriber Link Configuration
Page 73 of 254
screen.
April 17, 2015