Show - Redline RDL-3000 Series User Manual

RDL-3000 FAMILY
ulrate <id> <rate>
Set the Link maximum downlink uncoded burst rate (UBR).
id = Link ID number.
rate - Minimum downlink rates in MCS (modulation coding scheme).
usrauthmode <local> <radius>
Set the user authentication mode. Specify local services, the RADIUS server, or both
in combination.
local - use local authentication.
radius - Use the RADIUS server.
webtimeout <0-60>
Set the session inactivity timeout period for the Web management interface. Default
is 10 minutes.
0:
1-60:
wsdb
WSDB configuration settings (US only).
city - Contact City
contact - Contact Name
copygpspos - Get the latitude and longitude data from GPS coordinate if
country - Contact Country
email - Contact E-mail
height - Antenna Height
latitude - the latitude coordinate which will only be used when GPS is N/A. This
longitude - the longitude coordinate which will only be used when GPS is N/A.
owner - Owner Name
phone - Contact Phone
postal - Contact Postal Code
state - Contact State/Province
street - Contact Street Address
usegps - GPS precedence: If enabled, always use the latitude and longitude
off - Disable GPS input.
on - Enable GPS input.
x509auth <off | on>
Enable or disable authentication.
off - Allow network registrations without authentication.
on - Require authentication using X.509 certificates.

show

Use the show command to display system statistics.
70-00158-03-00
USER MANUAL
Timeout is disabled.
Timeout in minutes.
available
command is only available when GPS precedence is disabled.
This command is only available when GPS precedence is disabled.
coordinates from the built-in GPS receiver. Registration request can
not be sent without location information.
Proprietary Redline Communications © 2015 Page 140 of 254 April 17, 2015