Radio Frequency Safety / Sécurité Des Fréquences Radio; Personal Safety; Electrical Safety; Electrical Safety Compliance / Conformité À La Sécurité Electrique - Redline RDL-3000 Series User Manual

RDL-3000 FAMILY
Ce produit est destiné à être connecté à une source d'énergie selon la norme IEEE
802.3at (42,5 à 57,0 VDC), qui doit être isolé électriquement de toutes les sources de
courant alternatif et fiable relié à la masse de la Terre. Ne pas installer les produits
Redline près n'importe quel type de ligne électrique. Si votre antenne ou du matériel
connexe entrer en contact avec des lignes électriques, des blessures graves ou la mort
pourraient en résulter!
Radio Frequency Safety / Sécurité des Fréquences Radio
The installer of this radio equipment must ensure that the antenna is located or pointed
such that the antenna does not emit RF fields in excess of the general population limits
as defined by:

FCC CFR 47, Part 2.1091
http://www.gpo.gov/fdsys/pkg/CFR-2009-title47-vol1/pdf/CFR-2009-title47-vol1-sec2-
1091.pdf

OET Bulletin 65,
FCC
devices
http://transition.fcc.gov/Bureaus/Engineering_Technology/Documents/bulletins/oet65
/oet65c.pdf

Health Canada limits for the general population; consult Safety Code 6, obtainable
from Health Canada's website:
http://www.hc-sc.gc.ca/ewh-semt/pubs/radiation/radio_guide-lignes_direct-eng.php

Santé Canada limite pour la population générale; consulter le Code de sécurité 6,
disponible sur le site Web de Santé Canada:
http://www.hc-sc.gc.ca/ewh-semt/pubs/radiation/radio_guide-lignes_direct-fra.php

Personal Safety

WARNING: HOT SURFACE. DO NOT TOUCH.
The radio platform is rated for operation at extreme ambient temperatures. When
operating in high temperature conditions, the chassis surface area can be higher than
the ambient temperature and personal thermal protection should be employed for any
maintenance or inspection activity.

Electrical Safety

The equipment meets the requirements for class I EN 60950-1 (protection against
electric shock).
All external circuits are TNV-1 (as defined in EN 60950-1).
1.
All equipment must be grounded before the power cable is connected.
2.
For electrical safety the DC power supply shall have reinforced insulation to the
3.
mains supply.
Electrical Safety Compliance / Conformité à la Sécurité Electrique
The RDL-3000 system hardware has been tested for compliance to the electrical safety
specifications listed in the following table.
70-00158-03-00
USER MANUAL
Attention au personnel du service: 48V CD
Radio frequency radiation exposure evaluation for fixed
Proprietary Redline Communications © 2015 Page 18 of 254
.
April 17, 2015