Xycom XVME-678 Manual page 58

Chapter 3 - BIOS Setup Program
3.3.4.2 Quick Boot (NQ/Y es)
When quick boot is selected, the system BIOS bypasses the floppy disk drive tests, memory tests, and
floppy disk drive boot on power-up or soft reset. The system initializes and boots from the fixed disk in
a few seconds.
CAUTION
During hard disk partitioning and formatting, the quick boot selection must
be set to No. Otherwise, an operating system missing error is displayed,
and the system does not boot.
NOTE
If yes is the option selected, memory is not tested and the floppy disk
drive(s) defined in the Setup Menu must be correct. Also, the system will
not boot from drive A.
3.3.4.3 Screen Saver (Disabled/10 min/30 minl1 hour)
This option allows blanking the screen after a specified period of keyboard inactivity. This ensures that
the data displayed does not permanently burn into the monitor. Blanking can be set to occur after 10
minutes, 30 minutes, or one hour, or this option can be disabled. Press any key to redisplay the screen
after the screen saver has been activated.
CAUTION
Do not enable the screen saver when running programs that do not use the
BIOS for keyboard handling, such as Microsoft Windows. If the screen
saver is enabled with these programs, the screen blanks after the specified
time, regardless of activity, and can only be restored by exiting the
program.
3.3.4.4 Keyboard Click (NQ/Y es)
If enabled, this function provides audible key press feedback by causing the BIOS to click through the
system speaker every time a key is pressed. This option is only valid for systems with a speaker connected
to the speaker jack (110).
3-14