Xycom XVME-678 Manual page 163

Index
o
Date 3-4
Diagnostics Menu 3-16
Diagnostics 3-17
Diskette Drives 0 and 1 3-20
Error Codes 3-25
Extended Memory 3-20
Finishing the Formatting 3-25
Fixed Disk Drive, formatting new 3-25
Fixed Disk Drives 0 and 1 3-21
Fixed Disk Surface, analyzing 3-24
Format Fixed Disk Menu 3-23
Formatted disk, formatting again 3-25
Interleave, setting 3-24
Keyboard 3-19
Monitor Type 3-21
Parallel Port Tests 3-22
Park Fixed Disks 3-16
Serial Port Tests 3-23
System Board 3-19
System Memory 3-20
Test Control Options 3-19
Using the Bad Track Table 3-24
Diskette Drives 0 and 1 3-5, 3-20
DOS FDISK command 3-25
DOS FORMAT 3-25
DRAM 1-4, 4-7
1 Mbyte 4-7
10 Mbytes 4-7
16 Mbytes 4-7
2 Mbytes 4-7
4 Mbytes 4-7
DTACK 4-12
E
EMS memory 3-5
EPROM 4-8, 4-9
EPROM memory map 4-8
EPROM/flash jumper (11) 2-4
Error codes 3-25
Extended BIOS Features Menu 3-13
Auto Park Disk 3-13
Keyboard Click 3-14
Keyboard Delay 3-15
Keyboard Rate 3-15
Numlock Boot State 3-15
Quick Boot 3-14
Screen Saver 3-14
Extended memory 3-4
1-2
F
FAIL LED 3-1
Fixed disk drive, formatting new 3-25
Fixed disk drives 0 and 1 3-5, 3-21
Fixed disk surface, analyzing 3-24
Floppy drive connector (P4) 2-10
Floppy drive controller 1-4
Format fixed disk 3-23
Formatted disk, formatting again 3-25
H
Hard drive controller 1-4
I/O address map 4-15
I/O addresses. unique to the XVME-678/688 4-16
110 port addresses 4-15
Auxiliary Interrupt 4-18
Control Register 1 4-17
Control Register 2 4-19
Control Register 3 4-20
Control Register 4 4-20
Control Register 5 4-21
Control Register 6 4-21
Status Register 1 4-18
Status Register 2 4-19
VMEbus HI Address 4-19
110 ports
Centronics-compatible parallel 1-5
RS-232C serial 1-5
IDE hard drive connector (P5) 2-11
Installation 2-1
Adding extended BIOS 2-20
DRAM 2-22
Into a backplane 2-17
Jumpers 2-2
Math co-processor 2-25
Interleave, setting 3-24
Internal Floppy and IDE 3-5
Internal LPT 3-7
Interrupts 4-22
Auxiliary maskable interrupts 4-22
Auxiliary non-maskable interrupts 4-25
IRQIO 4-12
IRQ12 Jumper (J8) 2-4