Epson RC620 Manual page 92

2. Installation
4. Select [Fieldbus Slave]-[General].
5. Make sure that the following are displayed.
6. Click <Close>.
Editing of input / output size
You can change the input/output size of PROFIBUS-DP slave board if necessary.
1. Select [Setup]-[System Configuration] and display the [System Configuration] dialog
2. Select [Inputs / Outputs]-[Fieldbus Slave]-[General].
82
(4)
Fieldbus Type
Fieldbus Slave ID : (Displays the configure switch node address)
Input Bytes
Output Bytes
box.
: PROFIBUS-DP
: 32 (default setting)
: 32 (default setting)
(5)
RC620 Option Fieldbus I/O Rev.8