Epson RC620 Manual page 40

2. Installation
13. The [Add New Board] dialog box appears.
14. When you finish adding the DeviceNet master board to the applicomIO Console
15. After the controller is rebooted, refer to the next section Master Mode and continue the
30
Confirm that "PCI-DVNIO" is displayed in [Board to Add]-[Board Type]
and click <OK>.
If the board cannot be detected, the following dialog appears. Make sure that the
board is correctly inserted.
application, reboot the controller.
14-1 Shutdown the applicomIO Console application.
When the applicomIO Console application shuts down, the message
below appears. Click <Yes>.
14-2 The next message dialog follows. Click <OK>.
14-3 Reboot the Windows.
step.
RC620 Option Fieldbus I/O Rev.8