Epson RC620 Manual page 38

2. Installation
3. Connect the board with the Fieldbus.
4. Start up the controller.
5. The DeviceNet master board is detected and the [Found New Hardware Wizard] dialog
6. The next dialog appears.
7. Select<Install the software automatically (Recommended)>.
8. Click <Next>.
9. The following dialog box appears.
28
box appears.
Select <No, not this time> and click <Next>.
Confirm that the detected hardware is "applicomIO PCI Boad 32K".
(6)
(7)
Necessary software is automatically installed.
(8)
RC620 Option Fieldbus I/O Rev.8