2. Installation
94
3. Connect the board with the Fieldbus.
4. Start up the controller.
5. The EtherNet/IP master board is detected and the [Found New Hardware Wizard]
dialog box appears.
Select <No, not this time> and click <Next>.
6. The following dialog box appears.
Confirm that the detected hardware is "applicomIO PCI Boad 32K".
(6)
(7)
7. Select <Install the software automatically (Recommended)>.
8. Click <Next>.
9. The following dialog box appears.
Necessary software is automatically installed.
(8)
RC620 Option Fieldbus I/O Rev.8