Epson RC620 Manual page 52

2. Installation
Board Installation
 Make sure that the power is turned OFF before installing/removing any
boards or connecting/disconnecting any cables. Working with the power ON
is extremely hazardous and may result in electrical shock and/or malfunction
WARNING
of equipment.
Follow the instruction below and insert the board into the dedicated slot of the controller.
1. Remove two screws (+) on the back side of the RC620 robot controller.
2. Remove the plate.
3. Insert the board into the slot along the guide.
4. Put the plate removed in the step 2 back and secure it with two screws.
42
RC620 Back
Top
Bottom
RC620 Option Fieldbus I/O Rev.8
Plate