Epson RC620 Manual page 107

RC620 Option Fieldbus I/O Rev.8
15. The following dialog box appears. Set the IP address for the EtherNet/IP master
board.
Select the IP address from [Configuration]. There are following three types (Do
not select "Flash Memory")
"Static (assign as fixed IP address)"
"DHCP (obtain from the DHCP server)"
"BOOTP (obtain from the BOOTP server"
If you select "Static (Fixed IP address)", enter the values in each item.
16. When you complete adding the DeviceNet master board to the applicomIO
Console application, reboot the controller.
16-1 Close the applicomIO Console application.
When closing the applicomIO Console application, the following message
appears. Click <Yes>.
16-2 The following message appears. Click <OK>.
16-3 Reboot the Windows.
17. After the controller is rebooted, refer to the next section Master Mode and
continue the step.
2. Installation
97