Configuring Initial Position - HIKVISION Positioning System User Manual

Thermometric bi-spectrum network
Table of Contents

Advertisement

User Manual of Thermometric Bi-spectrum Network Positioning system
When manual limit stops are set, you can operate the PTZ control panel
manually only in the limited surveillance area.
 Scan Stops:
When scan limit stops are set, the random scan, frame scan, auto scan, tilt scan,
panorama scan is performed only in the limited surveillance area.
Manual Stops of Limit Type is prior to Scan Stops. When you set these two
limit types at the same time, Manual Stops is valid and Scan Stops is invalid.
3. Click the PTZ control buttons to find the left/right/up/down limit stops; you can
also call the defined presets and set them as the limits of the positioning system.
4. Click Set to save the limits or click Clear to clear the limits.

5.3 Configuring Initial Position

Purpose:
The initial position is the origin of PTZ coordinates. It can be the factory default initial
position. You can also customize the initial position according to your own demand.
Customize an Initial Position:
Steps:
1. Enter the Initial Position Configuration interface:
Configuration > Advanced Configuration > PTZ > Initial Position
2. Click the PTZ control buttons to find a position as the initial position of the
positioning system; you can also call a defined preset and set it as the initial
position of the positioning system.
3. Click Set to save the position.
© Hikvision
Figure 5-3 PTZ Configuration
39

Advertisement

Table of Contents
loading

Table of Contents