4.1 Driving Behavior Configuration
Purpose:
Driving behavior detection is on by default. Configure driving behavior detection parameters to
achieve best analysis effect.
4.1.1 Calibrate IPC Position
Purpose:
Calibrate IPC position before enabling driving behavior detection.
Step 1 Go to Configuration > VCA > Driving Behaviors > IPC Position Calibration.
Step 2 Adjust IPC position to make the driver face image appear in red frame.
4.1.2 Configure Driving Behavior Analysis
Step 1 Go to Configuration > VCA > Driving Behaviors > Driving Behaviors.
Step 2 Select Camera No.
Step 3 Check behaviors to analyze and configure Alarm Time and Confidence Interval.
Alarm Time: Device alarms when the corresponding driving behavior lasts for the set time.
Confidence Interval: Available for on-the-phone detection and smoking detection. You are
recommended to use the default value.
Stop Detections when Driving in Low-Speed: The feature is valid when GPS positioning
succeeded.
Voice Alarm: When it is checked, device will send out voice alarm when a checked behavior is
detected.
Step 4 Click Save.
4.2 Configure People Counting
Step 1 Go to Configuration > VCA > People Counting.
Step 2 Select Camera No.
Step 3 Adjust the counting area (red frame) position and size.
Step 4 Set detection line (orange line) position and direction. Device counts people that passing the
detection line along the set direction.
Intelligent Analyzer User Manual
Chapter 4 Smart Features
20