Table of Contents
Advertisement
User Manual of Thermometric Bi-spectrum Network Positioning system
parameters.
6.6.2 Configuring Video Tampering Alarm
Purpose:
You can configure the positioning system to trigger the alarm actions when the lens is
covered.
Steps:
1. Enter the video tampering Settings interface:
Configuration > Advanced Configuration > Basic Event > Video Tampering
2. The motion detection function is applicable to both the optical channel and the
thermal channel, you need to select the Channel No. in the dropdown list to
configure.
3. Check Enable Video Tampering checkbox to enable the tampering detection.
4. Set the tampering area. Refer to Step 1 in Section 6.6.1 Configuring Motion
Detection.
5. Click
to edit the arming schedule for tampering. The arming schedule
configuration is the same as the setting of the arming schedule for motion
detection. Refer to Step 2 in Section 6.6.1 Configuring Motion Detection.
6. Check the checkbox to select the linkage method taken for the tampering. Notify
surveillance center, send email, trigger channel and trigger alarm output are
selectable. Please refer to Step 3 in Section 6.6.1 Configuring Motion Detection.
© Hikvision
Figure 6-50 Tampering Alarm
85
Advertisement
Table of Contents
