Detecting Dynamic Fire Source - HIKVISION Positioning System User Manual

User Manual of Thermometric Bi-spectrum Network Positioning system
Notify surveillance center, send email, trigger alarm output, etc. are selectable.
Please refer to Step 3 in Section 6.6.1 Configuring Motion Detection.
7. Click

6.6.7 Detecting Dynamic Fire Source

Purpose:
When you enable this function and fire source is detected, the alarm actions will be
triggered.
Steps:
1. Enter Configuration>Advanced Configuration>System>VCA Resource Type to
select Dynamic Fire Source Detection as VCA Resource Type.
2. Enter the dynamic fire source detection interface:
Configuration > Advanced Configuration > Smart Event > Dynamic Fire Source
Detection
3. Check the checkbox of Enable Dynamic Fire Source Detection to enable the
dynamic fire source detection.
The function of dynamic fire source detection can only be enabled for
camera 2.
 Sensitivity: Range [1-10], the smaller the value is, the fire source of lower
temperature can be detected.
 Dwell Time(s): Range [0-120]. You can set the dwell time of the positioning
system staying the position where detects the fire source when performing
auto scan, patrol, pattern, scheduled task, and park action.
© Hikvision
to save the settings.
Figure 6-56 Dynamic Fire Source Detection
90