Configuring Video And Audio Settings; Configuring Video Settings - HIKVISION Positioning System User Manual

Thermometric bi-spectrum network

Table of Contents

User Manual of Thermometric Bi-spectrum Network Positioning System

6.4 Configuring Video and Audio Settings

Steps:

1. Enter the Video Settings interface:

Configuration >Basic Configuration > Video / Audio > Video

Or Configuration > Advanced Configuration > Video / Audio > Video

2. Select the Channel No. in the dropdown list you want to configure and select the

Stream Type of the positioning system to main stream (normal) or sub-stream.

The main stream is usually for recording and live viewing with good bandwidth,

and the sub-stream can be used for live viewing when the bandwidth is limited.

Refer to the Section 6.1 Configuring Local Parameters for switching the main

stream and sub-stream for live viewing.

3. You can customize the following parameters for the selected main stream or

sub-stream:

Video Type:

Select the stream type to video stream, or video & audio composite stream. The

audio signal will be recorded only when the Video Type is Video&Audio.

Resolution:

Select the resolution of the video output.

Bitrate Type:

Select the bitrate type to constant or variable.

Video Quality:

When bitrate type is selected as Variable, 6 levels of video quality are selectable.

Frame Rate:

The frame rate is to describe the frequency at which the video stream is updated

Figure 6-28 Configure Video Settings

Table of Contents