Clearing Ptz Configurations; Configuring Ptz Control Priority - HIKVISION Positioning System User Manual

User Manual of Thermometric Bi-spectrum Network Positioning system
The time of each task cannot be overlapped. Up to 10 tasks can be
configured for each day.
5. Click

5.7 Clearing PTZ Configurations

Purpose:
You can clear PTZ configurations in this interface, including all presets, patrols,
patterns, privacy masks, PTZ limits and scheduled tasks.
Steps:
1. Enter the Clearing Configuration interface:
Configuration > Advanced Configuration> PTZ > Clear Config
2. Check the checkbox of the items you want to clear.
3. Click to clear the settings.

5.8 Configuring PTZ Control Priority

Steps:
1. Get to the configuration interface:
Configuration > Advanced Configuration> PTZ > Prioritize PTZ.
 The positioning system can be controlled by network and RS-485 signals. You
can set the control priority of these two signals.
 The operation of Operator is prior to that of User. When the Operator is
controlling the positioning system, the User cannot control it. When the
Operator finishes, the User can control the positioning system after the Delay
time. The Delay time can be set in Priority PTZ interface as shown follows.
2. Click to activate the settings.
© Hikvision
to save the settings.
Figure 5-11 PTZ Priority
44