Configuring Rs-485 - HIKVISION Positioning System User Manual

User Manual of Thermometric Bi-spectrum Network Positioning system
Configuration > Basic Configuration> System > Maintenance
Or Configuration > Advanced Configuration> System > Maintenance
2. Select Firmware or Firmware Directory.
 Firmware: when you select Firmware, you need to find the firmware in your
computer to upgrade the device.
 Firmware Directory: You need to find the directory where the firmware
locates. The device can find the firmware in the directory automatically.
3. Click to select the local upgrade file and then click
remote upgrade.
The upgrading process will take 1 to 10 minutes. Please don't disconnect
power of the positioning system during the process. The positioning system
reboots automatically after upgrading.

11.8 Configuring RS-485

Purpose:
The RS-485 serial port is used to control the PTZ of the camera. The configuring of
the PTZ parameters should be done before you control the PTZ unit.
Steps:
1. Enter RS-485 Port Setting interface:
Configuration> Advanced Configuration> System > RS485
© Hikvision
Figure 11-13 Remote Upgrade
Figure 11-14 RS-485 Settings
128
to start