User Manual of Thermometric Bi-spectrum Network Positioning System
Chapter 5 PTZ Configuration
5.1 Configuring Basic PTZ Parameters
Purpose:
You can configure the basic PTZ parameters, including proportional pan, preset
freezing, preset speed, etc.
1. Enter the Basic PTZ Parameter Configuration interface:
Configuration > Advanced Configuration > PTZ > Basic
2. Configure the following settings:
Basic Parameters: Enable/disable proportional pan, set the preset speed,
keyboard control speed, auto scan speed, and zooming speed.
Proportional Pan: If you enable this function, the pan/tilt speeds change
according to the amount of zoom. When there is a large amount of zoom, the
pan/tilt speed will be slower for keeping the image from moving too fast on
the live view image.
Preset Speed: You can set the speed of a defined preset from 1 to 8.
Keyboard Control Speed: Define the speed of PTZ control by a keyboard as
Low, Normal or High.
Auto Scan Speed: The positioning system provides 5 scan modes: auto scan,
tilt scan, frame scan, random scan and panorama scan. The scan speed can be
set from level 1 to 40.
Zooming Speed: The zoom speed is adjustable from level 1 to 3.
PTZ OSD: Set the on-screen display duration of the PTZ status.
Zoom Status: Set the OSD duration of zooming status as 2 seconds, 5 seconds,
© Hikvision
Figure 5-1 Basic PTZ Configuration Interface
37