Table of Contents
Advertisement
User Manual of Thermometric Bi-spectrum Network Positioning system
and set pre-alarm temperature as 50°C. The device sends pre-alarm when its
temperature reaches 50°C and it alarms when its temperature reaches 55°C
and only when the device temperature is lower than 52°C will the alarm be
cancelled.
5. Draw the Target Region: Select the rule and draw the corresponding
frame/line/point. Click
to draw the frame.
6. Set Temperature Difference Alarm: Click Temperature Difference Alarm to enter
the temperature difference alarm interface, up to four temperature difference
alarms can be set.
Temperature Difference Alarm only applies to the targets set by frame.
7. Set Alarm Linkage: Click Alarm Linkage to enter the alarm linkage interface and
set the linkage methods.
8. Click Save to save the settings.
© Hikvision
to draw the point. Click
95
to draw the line. Click
Advertisement
Table of Contents
