Configuring Audio Settings - HIKVISION Positioning System User Manual

User Manual of Thermometric Bi-spectrum Network Positioning system
and it is measured by frames per second (fps). A higher frame rate is
advantageous when there is movement in the video stream, as it maintains image
quality throughout.
Max. Bitrate:
Set the max. bitrate to 32~16384 Kbps. The higher value corresponds to the
higher video quality, and the higher bandwidth is required as well.
Video Encoding:
The Video Encoding standard can be set to H.264 or MJPEG.
Profile:
You can set the profile level to High Profile, Main Profile or Basic Profile.
I Frame Interval:
Set the I-Frame interval from 1 to 400.
SVC:
SVC is a video encoding technology. It extracts frames from the original video and
sends these frames to a video recorder which also supports SVC function when
the network bandwidth is insufficient.
4. Click

6.4.2 Configuring Audio Settings

Steps:
1. Enter the Audio Settings interface
Configuration > Basic Configuration > Video / Audio > Audio
Or Configuration > Advanced Configuration > Video / Audio > Audio
2. Configure the following settings.
Audio Encoding: G.722.1, G.711ulaw, G.711alaw, MP2L2 and G.726 selectable.
Audio Stream Bitrate: When the Audio Encoding is selected as MP2L2, you can
configure the Audio Stream Bitrate in the dropdown list. The greater the value is,
the better the audio quality will be.
Audio Input: When an intercom is connected to the positioning system, you
need to set this option to LineIn. When a microphone is connected to the
positioning system, you need to set this option to MicIn.
Input Volume: Slid the bar to turn up/down the volume. The value ranges from 0
© Hikvision
to save the settings.
Figure 6-29 Audio Settings
66