HIKVISION Positioning System User Manual page 58

User Manual of Thermometric Bi-spectrum Network Positioning system
The switch forwards the certificate of authentication server to the network

camera.
If all the information is validated, the switch allows the network access to

the protected network.
 For your privacy and to better protect your system against security risks, we
strongly recommend the use of strong passwords for all functions and network
devices. The password should be something of your own choosing (using a
minimum of 8 characters, including at least three of the following categories:
upper case letters, lower case letters, numbers and special characters) in
order to increase the security of your product.
 Proper configuration of all passwords and other security settings is the
responsibility of the installer and/or end-user.
Steps:
1. Connect the network camera to your PC directly with a network cable.
2. Enter the 802.1X Settings interface:
Configuration > Advanced Configuration > Network > 802.1X
3. Check the Enable IEEE 802.1X checkbox to enable it.
4. Configure the 802.1X settings, including user name and password.
The EAP-MD5 version must be identical with that of the router or the
switch.
5. Enter the user name and password (issued by the CA) to access the server.
6. Click
The camera reboots when you save the settings.
7. After the configuration, connect the camera to the protected network.
© Hikvision
Figure 6-17 802.1X Settings
to finish the settings.
57