Configuring Supplement Light - HIKVISION Positioning System User Manual

User Manual of Thermometric Bi-spectrum Network Positioning system
2. Set the RS-485 parameters and click
The Baud Rate, PTZ Protocol and PTZ Address parameters of the positioning
system should be exactly the same as those of the control device.

11.9 Configuring Supplement Light

This function is only applicable to certain model of positioning systems.
Steps:
1. Enter Supplement Light Setting interface:
Configuration> Advanced Configuration> System > Service
2. Check the checkbox to enable the Supplement light when the illumination is not
enough for the video monitoring.
3. Click the
© Hikvision
Figure 11-15 Setting Supplement Light
button to activate the settings.
to save the settings.
129