Configuring Network Settings; Configuring Tcp/Ip Settings - HIKVISION Positioning System User Manual

User Manual of Thermometric Bi-spectrum Network Positioning system
Purpose:
When the positioning system is taken to another time zone, you can use the Time
Zone function to adjust the time. The time will be adjusted according to the
original time and the time difference between the two time zones.
From the Time Zone drop-down menu as shown in Figure 6-5, select the Time
Zone in which the positioning system locates.
 Configuring Daylight Saving Time (summer time)
Purpose:
If there is the habit of adjusting clocks forward in your country in certain time
period of a year, you can turn this function on. The time will be adjusted
automatically when the Daylight Saving Time(DST) comes.
Steps:
(1) Enter the DST interface by Configuration > Advanced Configuration >
System > DST
(2) Check
(3) Set the date of the DST period.
(4) Click

6.3 Configuring Network Settings

6.3.1 Configuring TCP/IP Settings

Purpose:
TCP/IP settings must be properly configured before you operate the positioning
system over network. IPv4 and IPv6 are both supported.
Steps:
© Hikvision
Figure 6-5 Time Zone Settings
to enable the DST function.
to save the settings.
Figure 6-6 DST Settings
49