HIKVISION Positioning System User Manual page 82

User Manual of Thermometric Bi-spectrum Network Positioning system
1. Enter the motion detection setting interface:
Configuration > Advanced Configuration> Basic Event > Motion Detection
2. The motion detection function is applicable to both the optical channel and the
thermal channel, you need to select the Channel No. in the dropdown list to
configure.
3. Check the checkbox of the Enable Motion Detection to enable this function.
You can check the Enable Dynamic Analysis for Motion checkbox if you want the
detected object get marked with rectangle in the live view.
4. Select the configuration mode as Normal or Expert and set the corresponding
motion detection parameters.
 Normal
Figure 6-45 Motion Detection Settings-Normal
(1) Click
motion detection area.
(2) Click
• You can draw up to 8 motion detection areas on the same image.
• You can click
(3) Move the slider
detection.
 Expert
© Hikvision
. Click and drag the mouse on the live video image to draw a
to finish drawing.
to clear all of the areas.
to set the sensitivity of the
81