Table of Contents
Advertisement
User Manual of Thermometric Bi-spectrum Network Positioning System
Chapter 8 Record Settings
Before you start:
To configure record settings, please make sure that you have the network storage
device within the network or the storage card has been inserted in the corresponding
card slot. Refer to the installation guide for the location of the storage card slot.
8.1 Configuring NAS Settings
Before you start:
The network disk should be available within the network and properly configured to
store the recorded files, log files, etc.
Steps:
1. Enter the NAS (Network-Attached Storage) Settings interface:
Configuration > Advanced Configuration > Storage > NAS
2. Select the NAS type as NFS or SMB/CIFS. If you select SMB/CIFS, you need to enter
the User Name and Password.
3. Enter the IP address of the network disk. The default NFS storage format of file
path is /dvr/test as shown in Figure 8-2. And the default SMB/CIFS storage format
of file path is /test.
4. Click
Up to 8 NAS disks can be connected to the positioning system.
© Hikvision
Figure 8-1 Select NAS Type
Figure 8-2 Add Network Disk
to add the network disk.
108
Advertisement
Table of Contents
