Configuring Port Settings - HIKVISION Positioning System User Manual

User Manual of Thermometric Bi-spectrum Network Positioning system
DNS server.
 Check the checkbox of Enable Multicast Discovery, and then the positioning
system can be detected by client software in the LAN.
The router must support the route advertisement function if you select
Route Advertisement as the IPv6 mode.

6.3.2 Configuring Port Settings

Purpose:
If there is a router and you want to access the positioning system through Wide Area
Network (WAN), you need to forward the 3 ports for the positioning system.
Steps:
1. Enter the Port Settings interface:
Configuration > Basic Configuration > Network > Port
Or Configuration > Advanced Configuration > Network > Port
2. Set the HTTP port, RTSP port, HTTPS port and port of the positioning system.
HTTP Port: The default port number is 80.
RTSP Port: The default port number is 554.
HTTPS Port: The default port number is 443.
Server Port: The default port number is 8000.
3. Click
© Hikvision
Figure 6-8 DNS Server Settings
Figure 6-9 Port Settings
to save the settings.
51