Configuring Recording Schedule - HIKVISION Positioning System User Manual

110
User Manual of Thermometric Bi-spectrum Network Positioning system

8.3 Configuring Recording Schedule

Before you start:
Please make sure a local storage card is inserted in the positioning system or the
network storage is added to the positioning system, and the
Purpose:
There are two kinds of recording for the positioning systems: manual recording and
scheduled recording. For the manual recording, refer to Section 4.4 Recording and
Capturing Pictures Manually. In this section, you can follow the instructions to
configure the scheduled recording. By default, the record files of scheduled recording
are stored in the SD card (if supported) or in the network disk.
Steps:
1. Enter the Record Schedule Settings interface:
Configuration > Advanced Configuration> Storage > Record Schedule
Figure 8-7 Recording Schedule Interface
2. Check the checkbox of Enable Record Schedule to enable scheduled recording.
3. Set the record parameters of the positioning system.
Figure 8-8 Record Parameters
 Pre-record: The time you set to start recording before the scheduled time or
© Hikvision