Driving Behavior Configuration; Calibrate Ipc Position; Configure Driving Behavior Analysis - HIKVISION DS-MP1803 Quick Start Manual

Step 2 Check Enable.
Step 3 Select Platform Access Mode as Ehome.
Step 4 Configure the following parameters.
 Server Address Type: IP Address and Domain Name are selectable.
 Server Address: Enter the static IP address of iVMS server.
 Server Port: The default value for mobile surveillance platform is 7660.
 Device ID: The ID of the device registered on the Ehome platform. If you leave it empty, device
logs in to the platform with serial No.
Step 5 Click Save and reboot the device to activate the new settings.

5.4 Driving Behavior Configuration

Purpose:
Driving behavior detection is on by default. Configure driving behavior detection parameters to
achieve best analysis effect.

5.4.1 Calibrate IPC Position

Purpose:
Calibrate IPC position before enabling driving behavior detection.
Step 1 Go to Configuration > VCA > Driving Behaviors > IPC Position Calibration.
Step 2 Adjust IPC position to make the driver face image appear in red frame.

5.4.2 Configure Driving Behavior Analysis

Step 1 Go to Configuration > VCA > Driving Behaviors > Driving Behaviors.
Intelligent Analyzer Quick Start Guide
Figure 5-3 Platform Settings
19