User Manual of Thermometric Bi-spectrum Network Positioning System
Chapter 2 Network Connection
Before you start:
If you want to set the network positioning system via a LAN (Local Area Network),
please refer to Section 2.1 Setting the Network Positioning system over the
LAN.
If you want to set the network positioning system via a WAN (Wide Area
Network), please refer to Section 2.2 Setting the Network Positioning system
over the WAN.
2.1 Setting the Network Positioning system over the
LAN
Purpose:
To view and configure the positioning system via a LAN, you need to connect the
network positioning system in the same subnet with your computer, and install the
SADP or client software to search and change the IP of the network positioning
system.
For the detailed introduction of SADP, please refer to Appendix 1.
2.1.1 Wiring over the LAN
The following figures show the two ways of cable connection of a network
positioning system and a computer:
Purpose:
To test the network positioning system, you can directly connect the network
positioning system to the computer with a network cable as shown in Figure 2-1.
Refer to the Figure 2-2 to set the network positioning system over the LAN via a
switch or a router.
PT Camera
© Hikvision
Network Cable
Figure 2-1 Connecting Directly
12