Temperature Measurement And Alarm - HIKVISION Positioning System User Manual

User Manual of Thermometric Bi-spectrum Network Positioning system
capture.
 Add Original Data on Stream: Check the checkbox to add original data on
stream.
 Data Refresh Interval: Select the data refresh interval from 1s to 5s.
 Unit: Display temperature with Degree Celsius (°C)/Degree Fahrenheit
(°F)/Degree Kelvin (K）.
 Temperature Range: Set the temperature range.
3. Clcik Save to save the settings .

6.7.2 Temperature Measurement and Alarm

Purpose:
This function is used for measuring the temperature of detected spot and the device
compares temperature of selected regions and alarms.
Steps:
1. Enter Configuration > Advanced Configuration > Temperature Measurement
and Alarm.
2. Adjust the image to the scene for temperature measurement with the PTZ
control panel. Save current scene as certain preset.

You can set the preset in live view interface before and call the preset in the
temperature measurement and alarm interface.

You can set/ call/ clear the preset in temperature measurement interface.
3. Set the alarm rule: Select a temperature measurement rule from the rule list and
configure the parameters.
 Name: You can customize the rule name.
 Type: Select point, line, or frame as rule type.
 Emissivity: Set the emissivity of your target. Note: The emissivity of each
object is different.
 Distance (m): The straight-line distance between the target and the device.
 Reflective Temperature: If there is any target with high emissivity in the scene,
check the checkbox and set the reflective temperature to correct the
temperature. If no such target exists, uncheck the checkbox.
© Hikvision
93