Air Conditioning Compressor - Toro Outcross 9060 Service Manual

Air Conditioning Compressor

Removing and Installing the Compressor
Outcross 9060
18234SL Rev B
g255887
1. Cap screw
2. Shim (as required)
3. Lock nut (4 each)
4. Refrigerant hose (pressure)
5. Refrigerant hose (return)
6. Carriage bolt (3 each)
The air conditioning compressor used on the Outcross 9060 is a Sanden model
SD7H15. For air conditioning compressor repair procedures; refer to the
SD Compressor Service
Note: Replacement of the drier−receiver is recommended whenever the
compressor is serviced or replaced.
1. Disconnect the compressor electrical connector from machine wire harness.
The air conditioning system is under high pressure. Do not loosen
any system fitting or component until after the system has been
completely discharged by a certified air conditioning service
technician.
2. Have refrigerant evacuated from air conditioning system by a certified air
conditioning service technician. Disconnect the hoses at the compressor,
then cap the fittings and plug the hoses to prevent contamination from
entering the air conditioning system.
3. Loosen the bottom tensioner plate lock nut and relieve the belt tension.
Remove and inspect the V-belts for wear or damage. Replace the V-belts
in pairs as necessary.
Figure 150
7. Tensioner plate
8. Compressor
9. Bracket – front left
10. V-belt (2 each)
11. Pulley
12. Cap screw (3 each)
Guide.
WARNING
Page 9–9
Sanden
Operator Cab: Service and Repairs