Toro Outcross 9060 Service Manual page 50

Machine Faults (continued)
Fault ID Fault Title
P114C Front Traction
Hydraulic
Circuit -
Charge
Pressure Low
Note: If fault
P115C is also
present, a
charge circuit
issue exists
outside of
the traction
pump (steering
and/or lift
operation
will also be
affected).
Confirm
charge
pressure at
the test port
provided and
perform gear
pump (P4) flow
test.
P114D Hydraulic Fluid
Temperature –
Over Temp
P115C Rear Traction
Hydraulic
Circuit -
Charge
Pressure Low
Note: If fault
P114C is also
present, a
charge circuit
issue exists
outside of
the traction
pump (steering
and/or lift
operation
will also be
affected).
Confirm
charge
pressure at
the test port
provided and
perform gear
pump (P4) flow
test.
Troubleshooting: Attachment/Loader Problems
Controller
Fault Description
Action
Charge pressure in front
traction circuit is less
than 1103 kPa (160 psi)
Hydraulic fluid Maximum traction
speed is reduced
temperature has
exceeded 95° C (203°
F)
Charge pressure in rear
traction circuit is less
than 1103 kPa (160 psi)
Recommended Service Actions
1. Use the InfoCenter to verify pressure sensor
reading (TRACTION INPUTS–FRONT
TRACTION)
2. If no pressure reading is displayed:
A.
B.
C. Test the pressure sensor if possible and
3. Perform front traction pump (P1) flow and
relief valve test
1. Make sure the auxiliary load valve joystick
is not stuck in an enable position
2. Reduce traction speed
3. Allow hydraulic fluid to cool below 90° C
(194° F)
1. Use the InfoCenter to verify pressure sensor
reading (TRACTION INPUTS–REAR
TRACTION)
2. If no pressure reading is displayed:
A.
B.
C. Test the pressure sensor if possible and
3. Perform rear traction pump (P2) flow and
relief valve test
Page 3–12
Check front pressure sensor (left side
of traction pump) wiring and connector
Test the pressure sensor wiring
replace if necessary
Check rear pressure sensor (right side
of traction pump) wiring and connector
Test the pressure sensor wiring
replace if necessary
Outcross 9060
18234SL Rev B