Toro Outcross 9060 Service Manual page 54

Machine Faults (continued)
Fault ID Fault Title
C10A4 Parking Brake
Light Output -
Overcurrent
C10A5 Parking Brake
Light Output -
Open Circuit
C10B3 Optional Brake
Controller
Output - Short
to Battery
C10B4 Optional Brake
Controller
Output -
Overcurrent
C1314 3-Point Hitch
Raise Output -
Overcurrent
C1315 3-Point Hitch
Raise Output -
Open Circuit
Troubleshooting: Attachment/Loader Problems
Controller
Fault Description
Action
Overcurrent detected
on parking brake light
output. Indicates short
to ground.
Open circuit detected
on parking indicator
brake light output.
Low current detected on
optional brake controller
output. Indicates a short
to battery
Overcurrent detected on
optional brake controller
output. Indicates short
to ground.
Overcurrent detected
on 3-point hitch raise
output. Indicates short
to ground.
Open Circuit detected
on 3-point hitch raise
output.
Recommended Service Actions
1. Check the parking brake light output circuit
wiring and all of the output circuit connectors
2. Test the parking brake light output circuit
wiring
3. Test the parking brake light
4. Replace the T2: TDM (contact your
Authorized Toro Distributor for assistance)
1. Check the parking brake indicator light
output circuit wiring and all of the output
circuit connectors
2. Test the parking brake indicator light
3. Test the parking brake indicator light output
circuit wiring
4. Replace the T2: TDM (contact your
Authorized Toro Distributor for assistance)
1. Check the optional brake controller output
circuit wiring and all of the output circuit
connectors
2. Test the optional brake controller output
circuit wiring
3. Test the optional brake controller if possible;
refer to manufacturer documentation
supplier with brake controller
4. Replace the T1: TEC (contact your
Authorized Toro Distributor for assistance)
1. Check the optional brake controller output
circuit wiring and all of the output circuit
connectors
2. Test the optional brake controller output
circuit wiring
3. Test the optional brake controller if possible;
refer to manufacturer documentation
supplier with brake controller
4. Replace the T1: TEC (contact your
Authorized Toro Distributor for assistance)
1. Check the 3-point hitch raise output circuit
wiring and all of the output circuit connectors
2. Test the 3-point hitch raise output circuit
wiring
3. Test the hydraulic solenoid valve SP1 coil
4. Replace the T1: TEC (contact your
Authorized Toro Distributor for assistance)
1. Check the 3-point hitch raise output circuit
wiring and all of the output circuit connectors
2. Test the 3-point hitch raise output circuit
wiring
3. Test the hydraulic solenoid valve SP1 coil
4. Replace the T1: TEC (contact your
Authorized Toro Distributor for assistance)
Page 3–16 Outcross 9060
18234SL Rev B