Checking The Angle Indicator; Adjusting Tire Air Pressure - Toro Reelmaster 3100-D Operator's Manual

1. Positive (+) battery cable
Important:
If you ever remove the battery,
ensure that the battery clamp bolts are
installed with the bolt heads positioned on
the bottom side and the nuts on the top side.
If the clamp bolts are reversed, they may
interfere with the hydraulic tubes when you
shift the cutting units.
6. Coat both battery connections with Grafo 112X
skin-over grease (Toro Part No. 505-47) or light
grease to prevent corrosion.
7. Slide the rubber boot over the positive terminal
to prevent a possible short from occurring.
8. Install the battery cover.
4
Checking the Angle
Indicator
Parts needed for this procedure:
1 Inclinometer
Procedure
1. Park the machine on a flat, level surface.
2. Verify that the machine is level by placing
a handheld inclinometer (supplied with the
machine) on the frame cross rail, by the fuel
tank (Figure 6). The inclinometer should read
zero degrees when viewed from the operator's
position.
Figure 5
2. Negative (–) battery cable
1. Angle indicator
g011213
3. If the inclinometer does not read zero degrees,
move the machine to a location where a zero
degree reading is attained. The angle indicator,
mounted on the machine, should now read zero
degrees as well.
4. If the angle indicator does not read zero degrees,
loosen the 2 screws and nuts securing the angle
indicator to the mounting bracket, adjust the
indicator to attain a zero degree reading, and
tighten the bolts.
5

Adjusting Tire Air Pressure

No Parts Required
Procedure
Adjust the tire air pressure at each of the tires; refer to
Checking the Tire Pressure (page
Note:
The tires are over-inflated for shipping.
14
Figure 6
45).
g008873