Toro Outcross 9060 Service Manual page 309

Replacing Front Gear Box Seals
Outcross 9060
18234SL Rev B
g246822
1. Retaining ring
2. Hub
1. Remove the retaining ring and the hub from the gear box output shaft.
2. Remove the flange head screws and plate to access either shaft seal.
3. Carefully remove and discard the shaft seal.
4. Clean the gear box housing bore and cover the shaft splines with tape to
protect the shaft seal during installation.
5. Install the shaft seal and remove the tape from the shaft splines.
6. Install the plate and tighten the flange head screws from 24.5 to 32.5 N∙m
(18 to 24 ft-lb).
7. Apply anti-seize lubricant to the splines of the output shaft and hub, then
install the hub and retaining ring.
Figure 124
3. Flange head screw (4
each)
4. Plate (2 each)
Page 7–15 Traction and PTO Drive: Service and Repairs
5. Shaft seal (2 each)