Toro Outcross 9060 Service Manual page 91

Removing the Engine (continued)
Outcross 9060
18234SL Rev B
14. Remove the exhaust pipe from the engine; refer to
4–10).
15. Remove the Operator's platform; refer to
(page 8–6).
The hydraulic pump assembly weighs approximately 73 kg (160 lbs).
16. Support the hydraulic pump assembly.
17. Disconnect the hydraulic pump assembly at the front PTO gearbox.
18. Refer to General Precautions for Removing and Installing the Hydraulic
System Components (page 5–49)
the front PTO gearbox. Plug the hydraulic lines and cap the fittings to prevent
contamination from entering the hydraulic system.
19. Disconnect the PTO drive shaft at the front hub and slide the drive shaft
rearward.
20. Disconnect the battery positive cable at starter solenoid and the engine
ground cable near the left rear engine mount.
Make sure that the hoist or lift and load leveling bar used to remove
the engine can properly support the engine. The engine and gearbox
assembly weighs approximately 280 kg (617 lbs).
21. Connect a suitable hoist or lift and load leveling bar to the front and rear lift
tabs on engine. Do not allow the lift chains or straps to contact the DPF.
Removing the Operator's Platform
CAUTION
and disconnect the hydraulic lines from
CAUTION
Page 4–19
Exhaust System (page
Engine: Service and Repairs