Toro Outcross 9060 Service Manual page 57

Machine Faults (continued)
Fault ID Fault Title
C14C4 PTO Output
-Overcurrent
C14C5 PTO Output -
Open Circuit
C1514 Front
Hydraulic
Pressure
Sensor - Short
to Ground
C1515 Front
Hydraulic
Pressure
Sensor - Open
Circuit
C1524 Rear Hydraulic
Pressure
Sensor - Short
to Ground
C1525 Rear Hydraulic
Pressure
Sensor - Open
Circuit
C153C 3-Point Hitch
Raise Stall
Outcross 9060
18234SL Rev B
Controller
Fault Description
Action
Overcurrent detected on
PTO output. Indicates
short to ground.
Open Circuit detected
on PTO output.
Front hydraulic pressure PTO is disabled
sensor is shorted to and machine
ground (out of range enters limp mode
low)
after the machine
comes to a stop
Front hydraulic pressure PTO is disabled
sensor is open (out of and machine
range high) enters limp mode
after the machine
comes to a stop
Rear hydraulic pressure PTO is disabled
sensor is shorted to and machine
ground (out of range
enters limp mode
low) after the machine
comes to a stop
Rear hydraulic pressure PTO is disabled
sensor is open (out of and machine
range high) enters limp mode
after the machine
comes to a stop
3-point hitch raise Raise is
output is enabled, but disabled for
3-point hitch position paddle-controlled
sensor does not report attachments
movement
Recommended Service Actions
1. Check the PTO output circuit wiring and all
of the output circuit connectors
2. Test the PTO output circuit wiring
3. Test the hydraulic solenoid valve EH coil
4. Replace the T1: TEC (contact your
Authorized Toro Distributor for assistance)
1. Check the PTO output circuit wiring and all
of the output circuit connectors
2. Test the PTO output circuit wiring
3. Test the hydraulic solenoid valve EH coil
4. Replace the T1: TEC (contact your
Authorized Toro Distributor for assistance)
1. Check front pressure sensor (left side of
traction pump) wiring and connector
2. Test the pressure sensor wiring
3. Test the pressure sensor if possible and
replace if necessary
1. Check front pressure sensor (left side of
traction pump) wiring and connector
2. Test the pressure sensor wiring
3. Test the pressure sensor if possible and
replace if necessary
1. Check rear pressure sensor (right side of
traction pump) wiring and connector
2. Test the pressure sensor wiring
3. Test the pressure sensor if possible and
replace if necessary
1. Check rear pressure sensor (right side of
traction pump) wiring and connector
2. Test the pressure sensor wiring
3. Test the pressure sensor if possible and
replace if necessary
1. If 3-point hitch is moving:
A.
B.
2. If 3-point hitch is not moving:
A.
B.
C. Test hydraulic relief valve RV2 and
Page 3–19 Troubleshooting: Attachment/Loader Problems
Make sure 3-point hitch position sensor
is properly installed (mounting bracket
is stationary and sensor shaft moves
with lift arm pivot shaft)
Test the 3-point hitch position sensor
Make sure the hitch assembly is not
obstructed or over loaded
Service hydraulic cartridge valve SP1
and replace if necessary
adjust, service, or replace if necessary