Toro Outcross 9060 Service Manual page 355

Removing the Control Panel and Windshield Wiper Assembly (continued)
Installing the Control Panel and Windshield Wiper Assembly
Outcross 9060
18234SL Rev B
control panel wire harness from the roof harness. Remove the control panel
assembly.
5. Continue to disassemble the control panel as necessary.
1. Install all components previously removed from the control panel.
2. If the wiper motor or wiper linkage assembly was removed:
g256105
1. Wiper arm – RH (passenger side)
2. Linkage assembly
3. Wiper motor shaft
A. Verify linkage arm lengths and adjust as necessary.
B. Fit the wiper linkage shafts to the control panel, install the lock nuts and
tighten the nuts to 35 to 40 N∙m (26 to 30 ft-lb).
Note: The wiper motor shaft must be in its home position prior to
installing the linkage. Replacement wiper motors are shipped with the
shaft in the home position. You may also energize and operate the wiper
motor for at least one cycle to set the motor to its home position.
C. Align the linkage drive arms as shown (center arm cap screw head
upward) and fit the center arm over the wiper motor shaft. Tighten the
center arm cap screw from 11 to 12 N∙m (95 to 105 ft-lb).
3. Connect the control panel wire harness to the roof harness and install the
control panel assembly.
4. Install the windshield wiper rubber washers, cups, and lock nuts against the
roof panel. Tighten the lock nuts so the rubber washers deform enough to
assure tightness, approximately 14 N∙m (10 ft-lb) or less.
5. With the wiper motor in it's home position, install the wiper arms as shown
(RH driver side wiper parallel to roof and LH passenger side wiper parallel
to cab post). Install the flange nuts and tighten from 23 to 25 N∙m (17 to
18 ft-lb).
6. Connect the washer hoses at the bulkhead fittings.
Figure 153
(view from outside cab)
4. Center arm cap screw
5. Wiper arm – LH (driver side)
Page 9–13 Operator Cab: Service and Repairs