Removing and Installing the Compressor (continued)
Operator Cab: Service and Repairs
To prevent compressor oil from filling the compressor cylinders,
keep compressor in the same orientation as the installed position.
4. Remove the compressor from the bracket. Locate and retrieve any shims
(item 2).
5. Remove the tensioner plate from the compressor if necessary.
Note: Use shims as needed to minimize the gap between the compressor
and the bracket before tightening fasteners.
6. To install the compressor, follow this procedure in reverse order.
7. Adjust the compressor belt tension; refer to
Tension (page
9–5).
8. Have a certified air conditioning service technician evacuate the air
conditioning system completely, properly recharge the system with R134a
refrigerant and then leak test the system. air conditioning system capacity
is 2.5 pounds of R134a refrigerant.
IMPORTANT
Page 9–10
Adjusting the Compressor Belt
Outcross 9060
18234SL Rev B