Installing the Front Loader Control Valve
Outcross 9060
18234SL Rev B
1. Lubricate new O-rings and place them onto the fittings. If previously removed,
install the fittings into the valve ports; refer to
(SAE Straight Thread O-Ring Fittings) (page
2. Secure the valve assembly to the machine with 4 cap screws.
3. Remove the caps and plugs from the fittings and hydraulic lines and connect
the hydraulic lines to the valve; refer to
(O-Ring Face Seal) (page
4. Operate the front loader control valve. Check for hydraulic leaks and correct
if necessary.
5. Install the operator's console; refer to
Console (page
8–17).
6. Check the hydraulic fluid level and adjust if necessary before returning the
machine to service.
Installing Hydraulic Hoses and Tubes
5–8).
Removing and Installing the Operator's
Page 5–107
Installing the Hydraulic Fittings
5–10).
Hydraulic System: Service and Repairs