Toro Outcross 9060 Service Manual page 84

Removing the Radiator and Hydraulic Fluid Cooler (continued)
Installing the Radiator and Hydraulic Fluid Cooler
Engine: Service and Repairs
If the radiator or engine is hot, pressurized hot coolant can escape
and cause burns.
Do not open the radiator cap or drain the radiator when the coolant
is hot.
Ethylene-glycol antifreeze is poisonous.
Keep the coolant away from children and pets.
Keep the coolant in a labelled container.
Discard the coolant in accordance with local hazardous waste
ordinances.
3. Drain the coolant from the radiator.
4. Disconnect the upper and lower radiator hoses from the radiator. Disconnect
the reservoir hose at the radiator. Cover or plug the disconnected coolant
hoses to prevent contamination.
Note: The lower hydraulic hose can be easily disconnected at the bulkhead
below the vehicle frame.
5. Refer to General Precautions for Removing and Installing the Hydraulic
System Components (page 5–49)
the cooler.
6. Remove the fasteners securing the fuel cooler assembly to the hydraulic fluid
cooler and move the fuel cooler out of the way.
7. Remove the top nut plate, top bracket, isolator mount and the fan shrouds.
8. Carefully remove the radiator and hydraulic fluid cooler assembly from the
machine.
9. If necessary, remove the hydraulic fittings from the hydraulic fluid cooler and
discard the O-rings.
10. Cover or plug the openings in the hydraulic fluid cooler and radiator to
prevent contamination from entering the system.
11. Inspect the isolator mounts and all seals on the radiator frame and replace
as necessary.
1. Lubricate new O-rings and place them onto the hydraulic fittings. If previously
removed, install the fittings into the cooler ports using alignment marks made
during removal; refer to
O-Ring Fittings) (page
2. Position the radiator and hydraulic fluid cooler assembly over the lower
isolator mounts.
3. Install the isolator mount, top bracket and top nut plate.
4. Install the fan shrouds. Center the fan shroud around the fan blades before
tightening the shroud fasteners.
DANGER
WARNING
and disconnect the hydraulic lines from
Installing the Hydraulic Fittings (SAE Straight Thread
5–10).
Page 4–12 Outcross 9060
18234SL Rev B