Toro Outcross 9060 Service Manual page 320

Servicing the PTO Drive Shaft Cross Bearings (continued)
Installing the PTO Drive Shaft
Traction and PTO Drive: Service and Repairs
assembly. Make sure that all the bearing rollers are properly seated in
the bearing cage.
B. Press one bearing partially into the yoke.
Take care when installing the cross into the bearing to avoid
damaging the bearing seal.
C. Carefully insert the cross into the bearing and yoke.
D. Hold the cross in alignment and press the bearing in until it hits the yoke.
E. Carefully place the second bearing into the yoke bore and onto the cross
shaft. Press the bearing into the yoke.
F. Install the snap rings to secure the bearings in place.
G. Repeat procedure for the remaining bearings.
5. Make sure that assembled joint moves without binding. Slight binding can
usually be eliminated by lightly rapping the yoke lugs with a soft faced
hammer. If binding continues, disassemble the joint to identify the source of
the binding.
1. Apply a coating of grease to the slip yoke and tube yoke splines and fit the
slip onto the tube yoke.
2. Position the PTO shaft in the machine and secure the flange yokes to the
gear box hubs.
3. Apply Mobil high-temp XHP–222 grease or equivalent to the grease fitting
on the slip yoke.
4. Install the 2 shaft guards.
5. Grease the slip yoke grease fitting.
6. Install the PTO shaft cover.
7. Install the bed.
IMPORTANT
Page 7–26 Outcross 9060
18234SL Rev B