Toro Outcross 9060 Service Manual page 152

Filtering the Closed-Loop Traction Circuit (continued)
Hydraulic System: Service and Repairs
B. If the rear drive motor was serviced or replaced, disconnect the hydraulic
hose at the M1 port (right) of the rear drive motor.
g262503
(shown with front axle drive motor removed)
1. Tandem piston (traction) pump (P1) and
(P2)
2. B port
C. If the tandem piston (traction) pump (P1) and (P2) was serviced or
replaced, remove the front drive motor, drive coupler and motor mount to
access the desired filter connection; refer to
Leave the hydraulic lines connected to the drive motor.
D. If the front drive circuit is contaminated because front traction pump (P1)
failed, disconnect the hydraulic hose at the B port (middle right) of the
tandem piston (traction) pump.
E. If the rear drive circuit is contaminated because rear traction pump (P2)
failed, disconnect the hydraulic hose at the D port (middle left) of the
tandem piston (traction) pump.
5. Connect the temporary hydraulic filter in series between the disconnected
fitting and hose. Use a
sure that fittings and hose connections are properly tightened.
6. Fill the hydraulic tank with the correct type and quantity of new hydraulic
fluid; refer to the traction unit Operator's Manual.
7. Start engine and run at low idle speed. Check for and correct any hydraulic
leaks before proceeding.
Figure 36
3. D port
High Flow Hydraulic Filter Kit (page 2–17)
Page 5–56
Axle Motors (page 5–76).
and make
Outcross 9060
18234SL Rev B